StarTrac 5400 Bike Low Batt Error

Probable Cause

A) Faulty lower control board
B) Bad battery

Corrective Action

A) Check battery voltage. Access SYSTEM MEASUREMENTS mode by pressing and holding ENTER, 0, and 2 keys. Continue holding ENTER and 0 keys while releasing the 2. The unit will beep once and SERVICE SETTINGS will appear on the display. Release the ENTER and 0 keys. Press the 8 key. The message MEASUREMENTS will display. Use the SCROLL key to select battery voltage. This offers a battery voltage reading from an idle state. Verify battery voltage is between 6 – 7 VDC. If voltage is greater than 7 VDC, replace the lower control board.

B) Check battery voltage. If the display will allow, access SYSTEM MEASUREMENTS mode by pressing and holding ENTER, 0, and 2 keys. Continue holding ENTER and 0 keys while releasing the 2. The unit will beep once and SERVICE SETTINGS will appear on the display. Release the ENTER and 0 keys. Press the 8 key. The message MEASUREMENTS will display. Use the SCROLL key to select battery voltage. Verify battery voltage is between 6 – 7 VDC. If battery voltage is lower than 6.2 VDC, either battery needs recharged or replaced.

Related Items