StarTrac 5400 Bike No Load Error

Probable Cause

A) Faulty alternator
B) Bad wire harness

Corrective Action

A) Check the voltage at the alternator by placing the red lead of your volt meter on the alternator yellow wire/nut and the black lead on the alternator black wire/nut labeled "E". Verify voltage is 9 – 10 VDC. If voltage is correct, replace the alternator.

B) Check the voltage between the alternator and the lower control board. Place the read lead of your volt meter into the yellow wire at the J4 connector of the lower control board and the black lead of your volt meter on the alternator black wire/nut labeled "E". Verify voltage of 8 - 9 VDC. If voltage is not correct, replace the wire harness.

Related Items